[BaadAssGremlins] Gauges and Mounting

[AMC74HORNET@xxxxxxxxx]

What size gauges do you guy's have mounted in the A/C duct in the middle
of the dash? I have been using JB Weld to mount the plexi-glass flanges
to the plexi face plate I made. I should have it finished tomorrow. I
laid out a template and found out I can only fit three 2 1/16 gauges in
the stock factory pod so I chose Volt/Oil/Temp. I have just enough room
that maybe I can mount my battery cut off switch there too. I just
ordered them from Jeg's this afternoon. 100$ for 3 gauges shipped. 
"Doc"



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Help save the life of a child.  Support St. Jude Children's Research Hospital's
'Thanks & Giving.'
http://us.click.yahoo.com/6iY7fA/5WnJAA/Y3ZIAA/YtqqlB/TM
--------------------------------------------------------------------~-> 

 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/BaadAssGremlins/

<*> To unsubscribe from this group, send an email to:
    BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

--- Begin Message ---

• From: themixtoo@xxxxxxx
• Date: Tue, 01 Mar 2005 11:43:10 -0500

In a message dated 2/28/2005 10:24:22 PM Eastern Standard Time, Davis Martin <martin-davis@xxxxxxxxxxxxx> writes:

>Right now i have the gauges mounted in the center where the AC vents were in the dash.
> Davis
>
>
>Then again, I already have the A/C vent unit installed in the center of the dash (not hooked up to anything, but looks better than the vent delete plate) I was thinking of putting digital gauges mounted behind the grillwork (the stealth look)that way the dash would 'look' factory and you could still monitor the oil pressure etc. Just .02 more!  'The Mix'




--- End Message ---