Re: [BaadAssGremlins] Hornet parts for Doc
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [BaadAssGremlins] Hornet parts for Doc



The easiest although it may not seem so is to remove the bumpers. On the
front bumper there there is 5 screws holding it on, one at the very end
of each side. Then there is looking down with the hood open between the
grill and rad. one in the very center I believe it also holds the grill
and still looking down one on each end just before the fender headlight
bucket. These 3 screws may have to be unbolted from the bottom, It's
been a long time so I don't really remember. The rear is held on by
slide on clips slipped on studs that are welded on the body and there
may be a screw at the very end on each side also. Please save all
screws and clips for me. Hope this helps, like I said it's been a long
time since I removed these items. I think it was 1979 when I repainted
the yellow car. Thanks.
"Doc"

--- Begin Message --- Doc,
Tell me again how to get those plastic pieces off so that I can get
them to you. Went today to try but could not figure it out as could
not see how they are held on to the body. As soon as i get what I
need from this car I will be parting it out or selling what is left
whole if you know anyone that would like one reasonable.
                                                    Hal



--- End Message ---


Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated