Re: progress
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: progress



--- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin-davis@xxxx> wrote:
> 
> Thanks Lu,
> I got more done today the heads are on and so are the roller rockers. I will give more detail later. I have pics too but i still gotta upload em from the camera. 
> Davis 
> lumina333 <lumina3@xxxx> wrote:
> Sounds like ALOT of progress, Davis! Thanks for the assembly details -
> I will print it off for later use. Looking forward to viewing the 
> pictures.
> --- In BaadAssGremlins@xxxxxxxxxxxxxxx, "Davis" <martin-davis@xxxx> 
> wrote:
> > Well,
> > We started assembelling the engine last night. Worked on it till 
> > 12pm. Poped off the freeze plugs and (YUK!) cleaned as much crud 
> out 
> > as I could get to and then blew it out with an air hose. Installed 
> > new brass freeze plugs. I cleaned the cam bearings, lubed up the 
> new 
> > Isky cam with the suplied moly lube, and installed the cam. I then 
> > installed the timing set. Before installing the timing set There is 
> > some casting flash in the oil slot in the cam gear that had to be 
> > filed out( very important step) to make sure oil gets to the timing 
> > gears and dist gear. Next was to degree the cam. My cam is within 2 
> > degrees! Awsome. ( I sure am learning alot from Bill.(AMC Team grem 
> > owner)
> > Next was to see if I have enough valve to piston clearance with my 
> > modified heads. Out cme the playdough. Plenty of room :o)
> > Turned the motor over and poped off the rear main. Bearings look 
> ok 
> > slight scoring but stil nice for a 100k mile engine. Installed new 
> > rear main seals. Reinstalled main cap. Cleaned out oil pan bolt 
> holes 
> > and sump hole. Wiped gasket surface with MEK. Installed oil pic-up 
> > tube. Checked oil pan gasket fit. Sprayed block side of gasket with 
> > adhesive spray. Stuck gasket to block with all holes lined up. 
> > Installed my new Milodon Deep Sump oilpan using bolts from my new 
> > stainless steel engine bolt kit. Now its startin to look sweet!
> > ok roll engine back over. Put on new ROL head haskets and install 
> > heads. 
> > Call it a night.
> > still got lots to do but it is starting to come together. 
> > I will take a few pics today.
> > Davis :o)>
> 
> 
> 
> ---------------------------------
> Yahoo! Groups Links
> 
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/BaadAssGremlins/
> 
> To unsubscribe from this group, send an email to:
> BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx
> 
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

It's alway's rewarding to see a pile of parts come togeter. I have a liveing room full of dash parts that I have been working on for the last 2 months and I am finally able to see some progress and even a completion of them in the end of March.
"Doc"





Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated