Re: [AMC-list] Putting an AX-15 behind a 290 (was: Re: Fw:)

[Jim Blair <carnuck@xxxxxxxxxxx>]

Fitting the flywheel to the crank is the issue. I definitely have enough 4.0 flywheels around. I'll have to figure the offset and get it machined and rebalanced to work. 

From: markprice242 
To: "Rambler AMC, Nash, Jeep and family" 
Subject: Re: [AMC-list] Putting an AX-15 behind a 290 (was: Re: Fw:)
Message-ID:


Content-Type: text/plain; charset="utf-8"

You can get a 10.5" clutch on a 4.0L flywheel and it may theoretically align the 4.0L starter depending on the rear crank distance to the block. Why try and re-invent the (fly) wheel? Mark ----- Original Message -----
> From: "Jim Blair" 
> To: amc-list@xxxxxxxxxxxx
> Sent: Monday, November 28, 2011 5:34:21 PM
> Subject: [AMC-list] Putting an AX-15 behind a 290 (was: Re: Fw:)
> I'm looking at putting an AX15 behind my 290 and thought about using
> the 327 flywheel I have (since 290 ones all seem to have gone to
> scrap) to put a bigger clutch in, but I also wanted to run an XJ
> starter, so that may be a pipe dream. Anyone have ideas on this?
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://list.amc-list.com/pipermail/amc-list-amc-list.com/attachments/20111129/e8a2b351/attachment.htm>
_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com