Not strictly an AMC question, so please bear with me - I have to get this one solved. It's a general purpose thing. On my POS '91 Dodge pickup's 318 both exhaust manifolds have holes at the aft end for connections to various bits of emission control plumbing. The holes are smooth (not threaded) and next to them are threaded holes for clamping the connections in. One side actually has a tube connected to it; the other has (had) a little cover. However, in both cases the bolts are broken off, leaving gaping holes that are generating noise and venting a lot of unwelcome hot exhaust into the engine compartments. So I'd like to close them up, preferably without having to pull the manifolds, which would be a PITA. So does anyone make an expansion plug (as in: insert into hole, then tighten up a bolt/nut that squeezes the plug material, causing it to bulge out and seal the hole) that'll withstand exhaust manifold temperatures? These holes are in the 1/2" neighborhood. Thanks much. Jonathn _______________________________________________ AMC-list mailing list AMC-list@xxxxxxxxxxxx http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com