[Amc-list] Roller lifters for a 6 cylinder

[Nick ALFANO <71amx@xxxxxxxxxxxxx>]

Hey guys.  I haven't been on the list much later.  I have just not had the time not to mention the list was bouncing to my spam mail for some reason.   You know, out of site out of mind.  Anyway, I read someone say something about AMC 6 cylinders and roller cams.  Is there an interest in that.  My sales rep from Crane has talked to me about it a couple times in the past.  No one currently make a roller cam and lifters for an AMC 258.  I am not sure there are enough guys out there willing to put up the money for a roller cam combo in a 6 but I could be wrong.  If there is enough interest (I don't mean the typical "I would like one"), I can pursue it further.  Might take a while but I would be willing to do it if I got people to commit to a kit.  

Let me hear your feed back.  I am building a 6 right now with a nice size cam, 9.5:1 compression, 4 bbl intake and carb, ported head and dual outlet header for our Gremlin.  I would have put a roller cam in it if they were available.  I am a big fan of roller cams as most of you know.  The power gains and over all performance of them can't be beat for the money on the street or strip.  Plus, flat tappet cams are too prone to failure.

Thanks,

Nick
 Alfano Performance
4849-76 st.
Kenosha, WI. 53142
262-308-1302
262-942-8271 after 6pm central and weekends 
_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list