On March 27, 2006 mail@xxxxxxxxxxxx wrote: > I came across this company in an article some time back and here they have a > web site now. > It loks like they have a system useful system for restorations. > > http://www.northwestpolymers.ca/welders.html > > > I will paste that article on below also. It may have some ideas for your > projects. > > ___________________________________________________________________-- > > (Taken from Farm and Country March 15, 1999) > UNDER THE HOOD > > By Keith Berglind > > When duct tape doesn't cut it... > > A plastic Welding Primer > > © copyright 1999 Agricultural Publishing Company Limited. --------> Thank you. Thank you. Thanks. etc from that article... "...With some practice under your belt, you may want to try a burn or flame test. Take a slice or hidden part of the piece and burn it with a small open flame. " ---------> I know this should be unnecessary to say, but it IS the 21st Century, with all that THAT implies. BE CAREFUL doing this, as a VERY small whiff can absolutely kick your ass. Some of the chemical agents we protected ourselves from in the Army contain many of these same ingredients. Simple. Stay upwind. Ventilate. Etc. Don't feel like it's overkill to wear a respirator doing this stuff, especially if you have any respiratory conditions. The smoke can cause corneal problems on contact, including blindness. Doesn't mean don't do it, just watch out. After all, you shouldn't breathe or contact normal welding smoke from metal either. mike ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist