Well the test fit of the gauge panel went in with the usual struggle but it fits. The elongation of the bolt hole in the hand brake bracket worked out fine. I also added two 5/16" washers to shim it 3/16" so it does not make the dash frame bind. Without these seemingly small mods the dash frame was distorted and the gauge panel would not fit properly. Now I need to run the wires for the tac and drill the holes to install the manual choke next to the vent cable. I also added matching billet knobs to both so it all looks factory. The dash has billet knobs on everything. I even put billet knobs on the stock window roller cranks. With the exception of the gear shift lever, turn signal and 4 way flasher knobs all the rest had to be modified to fit the different shaft sizes. Some of them even needed to have a bit more taper machined into them to make the look and fit better for their application. I am a real pain about fit and detail. "Doc" ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist