Pull what you want to save. Go to Radio Shack & buy a spray can of TV Tuner Cleaner. If you just want to keep everything intact, use the Cleaner with that straw attatchment & blast it into areas you're concerned about. - Or - Dismantle what you can safely reassemble. Flush out with the Distilled Water. Dry with a Hand Held Hair Dryer or Heat Gun > don't melt anything. Go over the parts with the TV Tuner Cleaner. If you're using wire looms that plug together, Dielectric Grease once the TV Tuner Cleaner has evaporated > which is usually instantanious. You're "Good to Go". Brien. NEW YORK eagle registry #501 eagle kammback registry From: Dixiana <dixiana@xxxxxxxxxxxxxxxxxx> To: mail@xxxxxxxxxxxx Subject: Re: Well now isn't that special! If you really want to try saving the electronics, flush everything with lots of distilled water, hit them with some more distilled water, and then leave them to dry. "Non-distilled" water can and will leave conductive residue on things when it evaporates. Dave M. farna@xxxxxxx wrote: >Mark, even if water got in the gauges they should be fine now. If mud >got in there they may be jammed, but electrically everything should >work (if not badly corroded) as long as it's dry. Worse case is you >short a couple things out -- hook up a battery and stand by with the >fire extenguisher! Doesn't sound like there's much to lose if >something shorts. I seriously doubt anything would catch fire -- >insulation might melt off a wire but fuses or circuit breakers would >blow first, and you can cut power quick enough. You can always unplug >the steering column and radio before powering up since you want to >try saving those, just to be safe.