Re: was Re: SR-4/T-5 Yoke?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: was Re: SR-4/T-5 Yoke?



Obviously I remembered putting the T-96 up to the late bell, not the other way around. Well, that was 10 years ago! I must have been thinking I could drill the old bell for the two upper bolts then use the adapter to mount the lower ones. I had it worked out where I could make a 1/4" steel adapter, but necer went through with it. 

On July 21, 2005 Tom Jennings wrote:

> On Thu, 21 Jul 2005, Sandwich Maker wrote:
> 
> > if the t96/t14 and sr4/t4/t5 do share upper bolts that makes things
> > easier, but according to advance adapters they're completely different.
> > the old pattern is about 6.25" * 5.25"; the new is 7.92" between the
> > upper holes, 6.32" between the lower, and 6.27" top-to-bottom.
> 
> I just went out and measured my pre-72 and post-71 bells. These
> are six cylinder parts.
> 
> Old bell: T96 to 232
> New bell: T14 to 232
> 
> The bell for the T96 shares NO holes with the T14 bell.
> 
> My "late" bell is double-drilled though, it'll take the T14 or the
> T96 transmission, though the center hole is 4.75" on the late bell
> and about 4.25" on the early.
> 
> THe early bell is overall smaller, by 1 - 2" overall diameter
> (it's of course not exactly round).
> 
> Flange-to-flange depth on both is the same within 1/8".


=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist







Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated