Re: A Day in the Yard

[farna@xxxxxxx]

Just a note: won't a 66-69 interchange? Matt Haas is the expert there! Might be some minor mods to make and not direct bolt on fit IIRC, but Matt should have the details. Filling trim holes isn't that bad a job. Most 69 fenders will have them, as there were more 440s made than base models. 

On June 23, 2005 Mark Price wrote:

> Joe,
>   If your Junkyarding and between jobs. Keep an eye out for a nice drivers Fender for my 69 American. Ineedone with no side molding and as nice and straight as possible.
> I've searched high and low around here and always come up short.
> At this point I'm open to most any option to get a nice rustfree fender. However, I still don't want to go broke getting one. This is for a later redo on my American. I'm gathering rustfree parts to replace ones that have been patched and repaired.
> I figure shipping on a fender might be a bit high. But not so high as to stop me from buying one. Anyone know what it would cost?
> Mark Price
> mpriceATwestco.net
> Morgantown, WV
> 69 AMC rambler, 4.0L, EFI, 5 speed
> 65 Ambassador Conv, 327 AUTO, Basketcase
> 01 S-10 CREWCRAP 4X4
> 
> 
> 
> ---------- Original Message ----------------------------------
> From: JOE FULTON <piper_pa20@xxxxxxxxxxx>
> Reply-To: mail-From-mprice-westco.net@xxxxxxxxxxxx
> Date:  Wed, 22 Jun 2005 18:57:52 -0700 (PDT)
> 
> >I have plenty of time to go junkin' now since I am
> >between jobs.  I got a tip from a SoCal AMX Club
> >member that there was a 73 Hornet 2-door in  the
> >PicKNPull yard on Mowry in Newark, CA.  Thanks Shelby,
> >if you are reading this.
> >
> >I went up there today and found the car.  It was
> >complete except for the instrument cluster and was
> >very clean inside, looking like an old woman's car.
> >
> >The interior plastic and dash pad were not damaged by
> >the sun so I got most of the plastic in front.  Tan.
> >I got both front fenders for the Hornet AMX I picked
> >up a few weeks ago.  Here again, I don't know if I
> >will ever put the Hornet AMX together, but I continue
> >to gather parts to make it a better project for
> >someone.
> >
> >Tom Jennings, I'll return you dash pad to you.  The
> >one I got today is at least as good.  Thanks for all
> >the trouble you went to in mailing it.
> >
> >There is a 77 FSJ in the yard with a 401.  I may go
> >and pull it Friday if it is still there.
> >
> >Joe Fulton
> >
> >Salinas, CA
> >
> >
> >
> >


=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist