If you're using a standard trans you can use that crank and rods. It might even work better with the AW4 flex plate as you have to modify it to fit the TF crank snout. Bell housing pattern on block won't matter as you need a 4.0L block. On May 26, 2005 Widiker, John D wrote: > Odd small bellhousing pattern, BW crank snout, if it were newer I'd keep > if and make a fuelie stroker out of the 4.0 but it's not. > > ~John > > -----Original Message----- > From: Greg Taylor [mailto:amundaza@xxxxxxxxx] > Sent: Thursday, May 26, 2005 2:17 PM > To: mail@xxxxxxxxxxxx > Subject: RE: Engine for Sale Not Mine amc 304 engine/trans - $100 > > > > --- eagle@xxxxxxxxxxx wrote: > > Think it would go into my Eagle? > > Rick > > > Yes and no. The eagle engine blocks have threaded embosses that the > front axle gets bolted to. The older 258's do not. You'd have to fab > up the mounts to hang the axle. > > Also, I think that era 258 had the OLD bell hsg pattern ... can anyone > confirm? > > Sincerely, > Greg Taylor :) <>< > Rochester Hills, Michigan USA > > "I am the resurrection and the life. He who believes in me will live, > even though he dies; and whoever lives and believes in me will never > die. Do you believe this?" - Jesus Christ (John 11:25-26) > > > > __________________________________ > Yahoo! Mail > Stay connected, organized, and protected. Take the tour: > http://tour.mail.yahoo.com/mailtour.html > > > > > > > > > > . ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist