Great report, Bruce! Has anyone done anything similar with an AMC?? Dwight On May 9, 2005 Bruce Hevner wrote: > >I have always been intrigued by my Dad's '86 Caprice which had a 305 > carbureted (Q-Jet) with a >700R4, a 2.29 rear axle ratio, weighing 4400 lbs. > would pull down 26 MPG on the highway at 75 mph. >This is what I know about > that engine: Bore/stroke is similar to a 304 AMC (3.736" x 3.48"), heads > >would flow around 200 CFM at .400" valve lift on the intake and around 145 > CFM on the exhaust at >.400" valve lift (1.84" intake valve, 1.500" exhaust > valve), about 8.5:1 compression, .357"/.373" >lift camshaft (176 degrees > intake @ .050", 194 degrees exhaust @ .050", 109 degree lobe >separation, > installed at 106 ATC), stock cast iron exhaust manifolds with a single 2.25" > exhaust >pipe and catalytic converter. The engine would literally loaf at > 1700 RPM on the highway, yet >still have enough power to be satisfactory to > drive. Surely we AMCers can do at least t > > I did a little experiment with kinda the same type thing. I had an 86 > Caprice Estate Wagon. I jerked out the 305 and tricked up a 350. Here's what > I did. Most of this would apply to an AMC too although you might have > trouble coming up with the same parts. > I decked the block so the "Squish" was .035. I used TRW flat pistons & > dished them in a "D" shape to match the combustion chamber and to achieve a > true 8.5 ratio. > I used 305 2-bbl heads that used 1.720 intake and 1.5 exhaust valves. I > used an Isky Mile-A-More cam (VERY short timing). The whole engine was built > with 4000 max RPM in mind. I had the trans rebuilt and shortened up the > shift points to 4200 max. > I installed a crank scraper to keep the oil off the rotating assembly. > I hit it pretty close, you could feel the power start falling off about > 3800. The thing had FANTASTIC throttle response and would actually turn the > tires a few times from a dead stop. > I used Michelin "energy" 225x15 tires (supposed to give better mileage). > On the hwy (loaded 4 adults) it would get 19-21 MPG,,, at 85 MPH!!! If I > slowed to 65 it jumped on up to 23-24. Around town 18-19 was about it. But > as above,, this thing was a BEAST weighing 4400 lbs! So essentially I had > the power of a 350 with the mileage of a 305. It had 235k on the clock (110 > on my motor) when the rear gear went south and I sold it. > Bruce Hevner ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist