Re: 304/290/200R4 - now V8 Fuel Mileage
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 304/290/200R4 - now V8 Fuel Mileage



I have followed this whole thread with some interest to see what input would be shared.  I feel like the original direction of the thread was abandoned somewhere along the way.  I would personally like to hear input on the subject of increasing fuel mileage on an AMC V8 powered car using modern technology and parts that are available.

What seems to be reasonable options for manual transmission selection would fall into these choices:
     1) Use an AMC T-5.  
     2) Adapt a Ford T-5.
     3) Use a T-4 or SR-4 with numerically low rear axle ratio.
     4) Adapt a GM T-5.
     5) Adapt a Richmond 5 or 6 speed.

For Automatic transmissions;
     1) Adapt a GM 700R4
     2) Adapt a GM 200R4
     3) Adapt a MoPar 500 or 518 series.

In all the cases above, rear axle ratio selection for the body/engine combination would be a factor to consider.

Then there is always the carburetor/camshaft/engine combination that comes into play.  And, of course, fuel injection can be discussed.

I suppose what I am asking for is input that can be accumulated for all to see and review in one place.  Maybe it could be submitted to the AMC Forums site and othere liek the AMCyclopedia site for referenece information.  Experiential information from those who have done the work would be especially valuable, and of course the cost.

I have always been intrigued by my Dad's '86 Caprice which had a 305 carbureted (Q-Jet) with a 700R4, a 2.29 rear axle ratio, weighing 4400 lbs. would pull down 26 MPG on the highway at 75 mph.  This is what I know about that engine: Bore/stroke is similar to a 304 AMC (3.736" x 3.48"), heads would flow around 200 CFM at .400" valve lift on the intake and around 145 CFM on the exhaust at .400" valve lift (1.84" intake valve, 1.500" exhaust valve), about 8.5:1 compression, .357"/.373" lift camshaft (176 degrees intake @ .050", 194 degrees exhaust @ .050", 109 degree lobe separation, installed at 106 ATC), stock cast iron exhaiust manifolds with a single 2.25" exhaust pipe and catalytic converter.  The engine would literally loaf at 1700 RPM on the highway, yet still have enough power to be satisfactory to drive.  Surely we AMCers can do at least that good, can't we?

Let the input begin.

Dwight Southerland

'67 Rogue 360/727 w/2.87 gears. 18 mpg.
     



=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist







Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated