Mark, You should be able to find a Snap-On dealer in your area. They service a lot of garages and repair shops. On Sat, 12 Feb 2005 09:17:44 -0500 <mail@xxxxxxxxxxxx> writes: > When I went frontline at the dealerships in 86 I went out and bought > $3,000 worth of tools to start off and one of the things I bought > was a Craftsman Torque wrench. It was junk then! Plastic grip, > plastic lock ring, both broke several times in the year it was under > warranty. That's why I bought the Snap on wrenches I have now. But > IIRC they where over $400 for the pair then! I went to Snap ons site > to see if I could find the manual on them to see what they actually > recommend for storage and it would cost $550+ to replace the two I > have now! Ouch! > I had no success in finding storage tips for my Snap on wrenches. > Anyone actually have any books on the Snap on Wrenches to see what > they really recommend for storage settings? > I think I'll try and e-mail Angle and see if they know what is > recomended. > Mark Price > > > ---------- Original Message ---------------------------------- > From: "Armand Eshleman" <aje1@xxxxxxxxxxxxxxx> > Reply-To: mail-From-mprice-westco.net@xxxxxxxxxxxx > Date: Fri, 11 Feb 2005 22:43:45 -0600 > > >Yeah I knew if I posted to the list about my torque wrench that > some one > >would come back with a place to send it to get fixed. For some > reason I just > >don't trust the Sears Stores around here because they all seem to > be run by > >a bunch of snot nosed kids who read numbers off monitors, or sell > appliances > >and electronics. And yes I actually still have the instructions > that came > >with it and thanks Randy Guynn for backing me up on the Sears > torque > >wrenches not being lifetime warranty. From what I see at the local > Sears > >Stores, Bob Villa better get his ass in gear and tell them to stop > with the > >cheap Chinese crap they've been selling lately and get back to the > good > >American made stuff. You know they don't carry any good quality > micrometers > >any more either, any way not around here. I think I'm going to ask > the Mac > >or snap on guy for help and if they can't I'm sending it to Angle > Repair. > >Any one actually ever deal with Angle Repair? > > > >Thanks all, > > > >Armand > > > > > > > > > > > > > > > > > > > > > > > > > > Jock Jocewicz - President/Editor NAMDRA NAMDRA@xxxxxxxx 8537 Antioch Rd., Salem, WI 53168 (262) 843-4326 http://www.namdra.org JOIN NAMDRA, the best AMC club around!!! AMO#19, NAMDRA#46, AMCRC#974, NHRA#41915, IHRA#6766