Re: 73 AMX in the sunshine.

["Todd Wallis" <cyclone@xxxxxxxxxxxxx>]

You can usually cover the holes with masking tape then drill (carefully) 
through the tape with out chipping the paint.

Todd W
----- Original Message ----- 
From: "JOE FULTON" <piper_pa20@xxxxxxxxxxx>
To: <mail@xxxxxxxxxxxx>
Sent: Saturday, October 30, 2004 6:20 AM
Subject: Re: 73 AMX in the sunshine.


> Bryan,
>
> It's a fine looking car.  You should be proud.  I too
> am putting a 73 Javelin back together now after a
> repaint and got a tip from a body man the other day.
> If your paint shop has partially filled the trim holes
> with bondo/primer/paint, enlarge them carefully, like
> with an appropriate size drill bit (hand held) so as
> not to chip the paint too much.  Then put some
> silicone sealer in each hole before applying the trim
> screw or clip to protect against rust and reseal the
> paint.
>
> Good Luck,
> Joe Fulton
> Salinas, CA
>
> --- teamamc <teamamc@xxxxxxxxxxx> wrote:
>
> >
> http://pg.photos.yahoo.com/ph/ufirst1111111/slideshow?.dir=/da18&.sr
> > c=ph
> >
> > I finally had some sunshine to  take some pictures
> > outside.
> > I have decided to paint some trees on the hood.
> >
> > The roof, trunk and Hood have been polished.
> > The sides still need to be done.
> >
> > I am pumped on this. Can't wait to reassemble.
> >
> > Let me know what you think
> > Thanks
> > Bryan