 
[AMC-list] Gremlin with Overdrive Question
     
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[AMC-list] Gremlin with Overdrive Question
- From: Joe Fulton <piper_pa20@xxxxxxxxxxx>
- Date: Thu, 10 Feb 2011 20:02:14 -0800 (PST)
I asked this same question on the AMC forum so pardon the repeat if you monitor 
both sites.  I'd appreciate any information folks can offer though.
I  am a few weeks away from installing this but I thought I would ask the 
question.   I have an NOS 150T three speed tranny with OD.   My Gremlin (76) had 
a T-14 in it.  I both trannies but I have not measured or compared the locations 
for the tranny crossbrace and mount and I'm wondering if the OD actually takes a 
special mount.  I'll check Rockauto listings tonight, but thought I'd ask the 
question.  
Another issue.  I have an NOS overdrive switch with turn signal stalk.   What I 
don't have is the wiring harness for the overdrive.   I can fabricate a harness 
from the wiring diagram in the TSM but I'm concerned about the cutout switch on 
the throttle linkage.  What did AMC use there?   What is a good generic switch 
to use?
Has anyone done this or does anyone have an 70s AMC with overdrive they can 
photograph?
Joe Fulton
_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com
 Back to the Home of the AMC Gremlin
 Back to the Home of the AMC Gremlin