[AMC-list] 199/early 232 crank flange bolt pattern same as V8?

[Jim Blair <carnuck@xxxxxxxxxxx>]

I'm looking to balance the nailhead flexplate for my 290, but the shop doesn't have a balancing shaft small enough to fit through the BW plate's center hole. I need a zero balance crank or I need to mod a later 6 crank to center it up on (cut the flex plate centering ring off).
   I know the early 6 cyls used a smaller diameter plate, but if where it bolts to the crank is the same pattern, all I need is an old one to get plates properly balanced for different engines (standard flywheels as well)

Jim Blair
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://list.amc-list.com/pipermail/amc-list-amc-list.com/attachments/20130722/93aa9cff/attachment.htm>
_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com