" From: Greg Taylor <amundaza@xxxxxxxxx> " " See below ... this is the engine that the $1000 291C heads were on .... " " " " " AMC 432 CID 401 " Reply to: sale-1039073443@xxxxxxxxxxxxxx " Date: 2009-02-17, 3:55PM " " KustomKemps built AMC 401 bored (4.25") and stroked (3.8") to 432 CID. " Built for the 2006 Jegs/Popular Hot Roding Engine Masters Challenge, " but not finished in time, so we took another engine. 10.5:1 " compression ratio allows running on pump gas premium. (race gas NOT " recommended). THIS ENGINE IS FULLY DYNO TESTED, AND READY TO DROP IN " AND GO. From the top down: Brasswell 1000 CFM carb, ported Herman " Lewis intake w/2" Wilson swirl spacer, fully ported Herman Lewis " aluminium heads w/coated combustion chambers & exhaust passages, " titanium valves are 2.15" I and 1.65" E, Yella Terra rackers are 1.7 I " and 1.6 E, Crane solid roller cam, Milodon gear drive, hardened " KustomKemps stroker crank w/Clevite coated bearings, Carrillo 6" rods, " J&E forged pistons, 8QT KustomKemps oil an w/external pickup, ATI " balancer, Hays 15LB SEMA approved flywheel and Center Force clutch " assembly. All our special oiling modshave been done including sleeved " lifter bores. Reply to "kustomkemps@xxxxxxxxx", or call (503) " 708-0810. Search "americanmotorsandjeepenginebuilders" for more info " on this engine and our other products and services. there are several web hits for 'kustomkemps', but i'll bet these folks are http://american-motors-jeep-engines.com/index.htm they don't seem to have anything for inlines though ;^< ________________________________________________________________________ Andrew Hay the genius nature internet rambler is to see what all have seen adh@xxxxxxxxxxxxxxxxx and think what none thought _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list