Re: [Amc-list] Part numbers again - rotor, condensor, points

[Wrambler242@xxxxxxxxxxx]

if you're, or anybodyis worried you can swap the bushing over from the Rambler delco too!
I had a GM hei with a bad bushing and needed a quick fix.
  I knocked the bushing out of one of the AMC delcos I had and it went right into the hei.
It was not as long as the gm bushing, but diameters were the same.
  I put the gm hei in a boat that cruised at about 3500-4700rpm. it ran for quite few years on that amc bushing with no issues.

--
Mark Price
Morgantown, WV
1969 AMC Rambler, 4.0L, EFI, T-5
2004 Grand Cherokee Laredo, 4.7L, Quadratrc II
" Chronic Pain Hurts"

 -------------- Original message ----------------------
From: adh@xxxxxxxxxxxxxxxxx (Sandwich Maker)
> " From: Tom Jennings <tomj@xxxxxxx>
> " 
> " On Tue, 26 Feb 2008, Sandwich Maker wrote:
> " 
> " > the hei gear is different because chevy six cams - gear driven - turn
> " > the opposite way from amc.  an amc delco gear works.
> " 
> " 
> " Hmm... then it would make for a bad swap, if the HEI dist uses
> " the spiral groove in the shaft to draw oil up it.
> 
> there are lots of hei swaps out there though, mine included [with
> the better part of 50k on it].  if this was a problem, wouldn't the
> word be out?
> ________________________________________________________________________
> Andrew Hay                                  the genius nature
> internet rambler                            is to see what all have seen
> adh@xxxxxxxxxxxxxxxxx                       and think what none thought
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list