Re: [Amc-list] Turbo Gen. 1 AMC Engine

[Wrambler242@xxxxxxxxxxx]

I don't have it, need to start reresearching things.
If anyone finds anythign on head info for the GEN I pass it along.
I have Datsons, "books" here somewhere and as et of heads I need to drag in and start looking at.
I'm think of looking for some compatable valves with reduced stem sizes to increase flow some with out major work to overly enlarge the seat areas.
--
Mark Price
Morgantown, WV
1969 AMC Rambler, 4.0L, EFI, T-5

 -------------- Original message ----------------------
From: "Brien Tourville" <hh7x@xxxxxxxxxxx>
> 
> Did anyone save the site info. from the Turbo Gen. 1
> engine project ?
> 
> I found the URL - but it is defunct - tried 'the wayback' 
> but no information was available.
> 
> 
> Who ended up with that engine - anyone from here ?
> 
> 
>         =Bt=
>   milnersXcoupe
>    "The Heretic"
> 
> 
> 
> 
> From: Wrambler242@xxxxxxxxxxx
> Subject: Re: [Amc-list] 287 pushrods needed
> 
> 
> If you insist on a full set of hollow pushrods all you have to do is
> measure the ones you have and get a set made. You might want to check
> for
> proper preload with your new lifters first.
>   The only 287 blocks that are reported to take a 4" bore are 63-64
> blocks
>   that do not have the bore size cast into them... Finding one in a 
> 65
> is
>   highly unlikely, although you never know the engine could have
> been
>   replaced at some point in the past.
> Share any info you come across on building these engines. 
> I'll do likewise.
> 
> Mark Price
> Morgantown, WV
> 1969 AMC Rambler, 4.0L, EFI, T-5
>   
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://www.amc-list.com/mailman/listinfo/amc-list

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list