Re: [Amc-list] Bellhousing shim plate for 1967 232

[Wrambler242@xxxxxxxxxxx]

Yeah, I saw that after I sent the reply. It might have something to do with Percocet?
Go figure!
It is strange though that they flipped back and forth steel-aluminum-steel with seemingly no rhyme or reason.
I have one or two of the plates down in the shed, but there is no way I could even get to them to measure the thickness.
No that I hope to be up and running again, I'll be building a new storage shed. It is much needed. The one I have now is a 10X13 Arrow steel building on a rotted wood platform. It's in the wrong place, always damp, and it is stuffed full of Rambler parts to the point I can't get in it.
   The new one will be 12X16 with a gambrel roof built using the 16' as the width so it will store car parts, ground floor will hold the wood working tools. When all is cleaned then the plan is to move the steel panels fromt he existing shed to one side of the new building and it will then be the parking for the bikes, mowers and misc.
   All this will be built mostly from recycled theatrical lumber from sets. I whould end up with very little cash in a nice hopefully permanent storage building. RM strikes again!

--
Mark Price
Morgantown, WV
1969 AMC Rambler, 4.0L, EFI, T-5

 -------------- Original message ----------------------
From: Tom Jennings <tomj@xxxxxxx>
> On Thu, 1 Mar 2007, Wrambler242@xxxxxxxxxxx wrote:
> 
> > Not sure when they changed over, but my 82 setup came with the new improved 
> liteweight plate!!!...............
> 
> But this is a pre-72 plate... weird. I know my 63 classic has
> steel (70 motor, 65 trans), and the hornet (83 motor, 72 trans)
> has steel.
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://www.amc-list.com/mailman/listinfo/amc-list

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list