i have swapped radiators fto and from AMX, Javelin, and Gremlins so it should also include hornets as well. Hope that helps Davis "Widiker, John D" <john.widiker@xxxxxxx> wrote: Cross flow of the correct width is 19 inches high, that height allows for mounting higher or lower for the reduced height cars. The inlet/outlet are going to be in slightly different locations then stock (few inches), I'll have the hoses that fit available and will also supply a part number for people who wish to source their own. I think I can accommodate both with the same rad. I'm going to look for someone local (s/e Michigan) to measure against more cars then just the AMXs I have around. In front or behind mounting I can accommodate as well it's just going to require getting my hands on something with the other scheme. ~John -----Original Message----- From: amc-list-bounces@xxxxxxxxxxxx [mailto:amc-list-bounces@xxxxxxxxxxxx] On Behalf Of John Elle Sent: Tuesday, January 30, 2007 11:05 PM To: amc-list@xxxxxxxxxxxx Subject: [Amc-list] Re; Radiators List Snip Drag rules call for a catch can, but I would think the low tank rad would need a true recovery system. It seems inappropriate to not have one anyways, except for showable originals. Who wants to have to refill a radiator all the time? That juice is expensive! I'd bet those buying a fancy radiator have already added one. They're only 10 bucks. Snip When I lived in Southern California and as my original Blackstone radiator became progressively more plugged on my Donohue it got to the point on those 90 degree plus days that having the radiator full to the top was the difference between running hot or not. Of course as water expanded from the heat it would dribble out through the over flow and the car would run hot. So I installed a catch can! ($10.00 sounds about right) It kept things going for quite a while until I moved to Arizona. 110 degree heat plus is a whole 'nother matter. I pulled my 160 thermostat and installed a 145 degree unit. A new radiator cap, and eventually a Kwick Kooler Water pump and modified the thermostat for increased coolant flow. I also installed open chamber heads that reduced the compression to about 9.5:1 That finally got things back under control. (Mostly) But as Tom pointed out, keeping things from running too hot also keeps pinging and pre-ignition problems down. As summer rolled around I had to run the timing a bit late to keep from pinging but winter was o.k., until--------------I sprung a leak in the core of my Original Blackstone radiator. A check to Jeff Kennedy at Kennedy American got a Desert Kooler radiator by return mail and installed. SHAZAAM as they say! The heat gauge stays pegged at the bottom of the normal run mark. My guess is that is 145 degrees as that thermostat is still in there. The only time I saw it move above that point is when I got caught in traffic and it was 121 degrees. It was about 15 miles on the freeway in stop and stop traffic. It got a bit warm that day. On the Donohue, a 390 I run a 145 degree thermostat modified for increased water flow, a kwick kooler water pump, an AMC fan shroud (metal), the stock AMC fan, a 16# radiator cap and an over flow tank. I can run all the distributor advance that 91 octane gasoline will allow me to run year around with no problems. On the 80 AMX I run a 170 degree thermostat, a fresh larger A/C radiator, stock water pump, a 12 # radiator cap and a fan shroud. It handles the heat well. On the 80 Spirit I run a 195 degree thermostat as the fuel injection does not like things cooler, a rebuilt 3 core A/C radiator, stock water pump, a 12# radiator cap, a stock fan and a fan shroud. It will run cool in heavy traffic with the A/C running. By the way, all three of these cars compete in various shows. You are not going to run into much of a problem unless you are competing at a deep pockets show and in 20 years of showing, I have never attended one of those. John. -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.amc-list.com/pipermail/amc-list/attachments/20070130/84621252 /attachment.htm _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://www.amc-list.com/mailman/listinfo/amc-list _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://www.amc-list.com/mailman/listinfo/amc-list -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.amc-list.com/pipermail/amc-list/attachments/20070131/9df23a01/attachment.htm _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://www.amc-list.com/mailman/listinfo/amc-list