Re: [AMC-List] 401X Race Block

[Tom Jennings <tomj@xxxxxxx>]

On Fri, 15 Dec 2006, Nick ALFANO wrote:

> I would tend to go along with you that they didn't
> really exist except I inspected it yesterday.  It does
> have the 401 cast into the side of the block, there
> definitely is an "X" stamped above the casting and it
> is a 3.750 bore.  The water jackets are much larger
> than a normal AMC V8.  Looking at the size of them, I
> doubt this engine could be bored more than .060 over
> the 3.750 bore.  The oil return holes in the intake
> valley are plugged and it had 4 bolt mains at some
> point in it's life.  The part number shows it is a 401
> but the bore is definitely not.  There is also "401"
> cast into the valley section of the block.  This is
> not some homemade job.  It is definitely cast into the
> block.  The casting marks are much more pronounced on
> this block than normal.  The block has been tanked and
> blasted down to a bare casting so there is no hiding
> what is there. 

Wow, that's pretty spectacular. Where did you get it? Where
did it come from?

Where there heads that came with it?

_______________________________________________
AMC-List mailing list
AMC-List@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list

or go to http://www.amc-list.com