Re: Gremlin Bell

[adh@xxxxxxxxxxxxxxxxx (Sandwich Maker)]

" From: Michael Bailey <route66rambler@xxxxxxxxx>
" 
" 
"   Just went out and crawled under the car for a look.  I'm going to e-mail a photo to frank.  Description of the bell housing:
"         
"     A narrow pattern of 4 drills where the t-14 was mounted.  6-1/4 inches wide X 5-3/8 inches high (approximate)

yup, that's the t-14/t-96 pattern, iirc ever since '63 or so when they
went to rear mount on the tranny instead of bellhousing.  earlier were
~4.25" vertically.

"     A wide pattern of 4 drills plus one extra.  8-1/2 wide by 6-1/2 high.  Additional drill is located on same vertical center as lower corner on passenger side, above it 1-1/2 inches.

this is the large t150 [ford] rectangle, plus maybe t-18/t-19 jeep 4sp.

the sr4/t4/t5 pattern is asymmetrical and between these in size.

next q: when you get to pull your t-14, what's the size of the bearing
retainer, and what's the size of the retainer hole on the bell?  my
guesses - 4.25" and 4.85".
________________________________________________________________________
Andrew Hay                                  the genius nature
internet rambler                            is to see what all have seen
adh@xxxxxxxxxxxxxxxxx                       and think what none thought